Farynozzle1.0
English • العربية • български • català • čeština • Deutsch • Ελληνικά • español • فارسی • français • hrvatski • magyar • italiano • română • 日本語 • 한국어 • lietuvių • Nederlands • norsk • polski • português • русский • Türkçe • українська • 中文(中国大陆) • 中文(台灣) • עברית • azərbaycanca • |
Release status: Working
Description | Open source hot end
|
License | Creative Commons By-SA 3.0 Unported
|
Author | |
Contributors | |
Based-on | |
Categories | |
CAD Models | |
External Link |
Description
The Farynozzle hot end is a Budaschnozzle based hot end, consisting of several pieces in various matherials detailed below. This hotend can work continuously for tenths of hours at up to 250ºC. It is very reliable and have been tested for printing with ABS and PLA.
Specs
Heater
By default, the Farynozzle comes with a Vishay RWM06226R80JA15E1 (6.8ohm) -> ~21W @12V. It has also been tested with a 40W heat cartridge succesfully.
Thermistor
The default thermistor used in the Farynozzle is a Honeywell 135-104LAG-J01. It is a 100k thermistor compatible with most firmwares. Can operate up to 300ºC with a 10% tolerance.
Parts
From up to down:
- Printable mount
- Wooden laser cut mount
- PTFE liner
- Hexagonal spacers
- Aluminium heatsink
- PEEK isolator
- Steel mount
- Wood mount
- Screws
- Aluminum thread
- Aluminum resistor block
- Nozzle
Planes
The planes are freely available on github here
Where to buy?
Farynozzles are produced in Zaragoza (Spain) in small amounts. Buy it in Farynozzle.com