FoldaRap Heated-Bed
|
English • العربية • български • català • čeština • Deutsch • Ελληνικά • español • فارسی • français • hrvatski • magyar • italiano • română • 日本語 • 한국어 • lietuvių • Nederlands • norsk • polski • português • русский • Türkçe • українська • 中文（中国大陆） • 中文（台灣） • עברית • azərbaycanca • |
> Back to the Bed-plate step <
Goal
(we used the same bed as the huxley but finally forked for a 3 point leveling)
Parts
x1
x1 (optional)
x1
x3
x3
- thermistor (26awg blue 30-35cm, ferules, kapton)
- kapton
Assembly
Tip : use the wood plate to center the position of the peltier
Plug the peltier in an adequate power supply (e.g : 12v) to check which side is heating. Don't worry if you put it wrong, you can always switch the cold/hot side by inverting the +/- wires on the board at any moment
don't pay attention to the small bolts
