PandaPi
Revision as of 15:19, 18 July 2020 by Danielkrah (talk | contribs) (Created page with " '''PandaPi Raspberry Pi Shield''' ---- File:PandaPiV2.png File:PandaPiV2.5.png {| class="wikitable" |- ! ! PandaPi V1.0 ! PandaPi V2.0 ! PandaPi V2.5 ! |- | Extr...")
PandaPi Raspberry Pi Shield
PandaPi V1.0 | PandaPi V2.0 | PandaPi V2.5 | ||
---|---|---|---|---|
Extruders | 2 | 2 | ||
Controlled Fans | ||||
Heaters | 3 | |||
Endstops | 3 | |||
Temp. sensors | 3 | |||
SWD | 1 (STlinkV2) | |||
Serial port chip | CH340G | |||
stepper driver | 6*(TMC2209/TMC2208/A4988)Modular, replaceable,uart for TMC2209 sensorless endstop | 6*(TMC2209/TMC2208/A4988)Modular, replaceable,uart for TMC2209 sensorless endstop | ||
Input | 9~28V 20A max | 9~28V 20A max | ||
heater Output | 15Amax | 15Amax | ||
MCU | stm32 | stm32 | ||
LCD | Graphic128*64/CrealityLCD128*64/HDMI | Graphic128*64/CrealityLCD128*64/HDMI | Graphic128*64/CrealityLCD128*64/HDMI | |
FAN | Support mixed use of 3V-24V fans | |||
filament detect pin | reuse the SWD pin | |||
Bed Leveling | BLtouch / support 5V~36V Inductive sensor NPN, since it have optocoupler. | |||
Protection | 4 autorecovery fuses and isolation components for over-current and reverse polarity protection for board,drivers,raspberry pi. |
Supported RaspberryPi | Pi 4B/3B/3B+
Fans
FAN0:hotend cooler,it will be opened if the temperature is higher than 60°C.
FAN1:model cooler, controlled by the gcode file or gcode command, M106: Set Fan Speed "M106 S255", M107: Fan Off.
FAN2:board cooler,If the driver is working, it will be opened.