RUG/Pennsylvania/State College/Electronics/Comparison
Revision as of 21:09, 29 November 2011 by Ksalitrik (talk | contribs) (Created page with '== Sanguinololu == === Pros === ** 7-30v * 2 thermistor * will do prussa * 2 n mos for extruder or for the bed * uart1 * i2c * spi * 1 pwm * 5 analog i/o * mostly through hol…')
Contents
Sanguinololu
Pros
- 7-30v
- 2 thermistor
- will do prussa
- 2 n mos for extruder or for the bed
- uart1
- i2c
- spi
- 1 pwm
- 5 analog i/o
- mostly through hold components
Neutral
- sdcard support is talked about but isn’t really visible
- usbttl needed
- prusa ok
Cons
- 4 popolu board’s stepper only
Generation 3 Electronics
Generation 7 Electronics
Pros
- slightly faster 25%
- can run heated bed off board
- usbttl needed
- 2 thermistor 1 for tip 1 for bed
- prusa ok
Cons
- also 4 boards 1/16 steps
Ramps
Pros
- allows additional arduino shields, like Ethernet...
- not really self etch able
- i2c
- spi
- 5 polo boards
- heated bed control 11 amp fuse
- prusa ok
- no usb adapter needed